Heat Tape,PROSPRAY-II, 1/8" Heat Conductive Green Rubber
TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
3
MINUTES
30
SECONDS
400
DEGREES
MEDIUM
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
Do NOT mirror or reverse image when printing transfer.
1. Place Nomex Felt Pad or 1/8" Heat Conductive Green Rubber on Bottom Table. When using 1/8" Green Pad add 1 additional minute press time.
2. Cover the Nomex Felt Pad or 1/8" Heat Conductive Green Rubber with a sheet of protective paper.
3. Use Heat Tape or Pro Spray to attach your transfer to the white side of the Coaster.
4. Place the Coaster with imaging side face up - textured side down, with attached transfer face down, on top of Nomex Felt Pad or 1/8" Heat Conductive Green Rubber and protective paper, on bottom table.
5. Cover it all with a piece of protective paper and press according to time, temperature, and pressure above. When using 1/8" Green Pad add 1 additional minute press time.
Application note: A wire brush can be used on the uncoated side of glass cutting boards to remove overspray. Do not use the wire brush on the coated side or the edges.
Updated: August 6, 2018
