Heat Tape
DyeTrans Multi-Purpose or TexPrint
OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
SECONDS
385
DEGREES
LIGHT; PSI 10
PRESSURE
Hover transfer under open heat press for 10 seconds to dry excess moisture.
Remove peel coat from inserts.If bottom platen is cold, begin by preheating for 15 seconds.
1) Lay protective paper on heat press platen.
2) Remove protective film from insert.
3) Lay insert imaging side face-down on transfer. Use heat tape or Pro Spray to keep it in place.
4) Add a piece protective paper over your transfer and insert.
5) Press. Add 2-3 seconds for each additional insert imaged at the same time.
NOTE: If you should see a void in the provided glue layer, add a drop of Super Glue to those areas prior to assembly of the product.
Updated: April 30, 2015
