ChromaLuxe Phone Inserts for U8450

Hover transfer under open heat press for 10 seconds to dry excess moisture.

Remove peel coat from inserts if it is on the metal. If bottom platen is cold, begin by preheating for 15 seconds.

1) Lay protective paper on heat press platen.

2) Remove protective film from insert.

3) Lay insert imaging side face-down on transfer. Use heat tape or Pro Spray to keep it in place.

4) Add a piece of protective paper over your transfer and insert.

5) Press. Add 2-3 seconds for each additional insert imaged at the same time. Too much pressure will cause a mottling of the metal finish.

NOTE: When adding the insert to the phone case, before you remove the protective paper covering the pre-glued area, start at one side and smooth out any air that may be trapped under the glue strip. Then you may remove the paper and insert the newly decorated insert. This will make the insert more secure.

NOTE: If you should see a void in the provided glue layer, add a drop of Super Glue to those areas prior to assembly of the product.
Should your phone case become soiled with use and wear, remove it from the phone and clean it with an ordinary household strength glass cleaner. Any remaining discoloration can be scrubbed off using glass cleaner and a non-scratch Scotch-Brite pad.

Updated: April 17, 2015